My signature card cuts off once email is sent

[realro66]

I cannot get my signature card to fully show up once the email is recieved. It looks fine when I am writing the email. it just shows up on the received email with the last 1/4 of it cut off.

Please help!:confused:

[bryan]

Try going into Plaxo, Tools, E-mail Signature, click Advanced, and adjust the width - increase it a bit.

Also, if you are using Word as your e-mail editor, you might try switching it off as Word has some problems rendering HTML. You can do this by going to Tools, Options, Mail Format, and there should be a checkbox at the top there.

[realro66]

I did go to advanced - numerous times, to change the width, height and then over and over again. As a matter of fact, it was when I did this the first time, that my signature never recovered.

It did in fact work correctly the first couple of times I sent an email and only after I played with the width, height did it get corrupted.

I've tried switching it every which way.